Don, I think I am getting a clearer picture of this converter thing. If stall speed is 3000, you can sit at a stand still (holding brake)with the engine reved up to just below the 3000 rpm without any movement. Go over the 3000 and the tires start trying to spin as if you were doing a brake stand burn out. But if you do not use the brake, the impellers in the converter will just act normal and you can cruise around in the 1200 rpm range and never really notice any difference from stock. I hope thats correct. Another question, I read where a guy said he put a variable stall speed converter in his car and it varies depending on load. I don't understand how that could work. Seems like the more you hold the brakes, the stall speed would just keep increasing till you reach your redline rpm. Doesn't make sense to me. If you don't mind Don, would you help on that one please. I want to thank you very much for all this info. It is helping me greatly. Harold (Dooner) Funderburk ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx bSONJP. Or send an email to: 1962to1965mopars-unsubscribe@