RE: Oil spill from the dist at accel

[Richard Kinsley <r.kinsley@xxxxxxxxxxxxxxxx>]

Jim Jablonski wrote:
> 
> Richard,
> 
> I would check that PCV valve to see if it is clogged or if perhaps it is 
> 
> the wrong application.  I have heard of excessive blowby pushing past 
> the distributor o-ring.
> 
> Regards,
> 
> Jim Jablonski
> Royal Oak, Michigan
> '64 Fury
--------------------------------------------------------------------

The PCV is clear and it's the same as was on the engine and in the same 
place, etc.. No changes there. The car doesn't smoke or leak otherwise. 
This has only happened a couple times but I do want to figure it out.


Rich Kinsley  '64 Polara 4 dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@