Don't bottom the yoke in the tailshaft for the measurement. I think you bottom out then pull out an inch or so. Doing it the other way will cause problems. --- "Bob H." <bhokanson@xxxxxxxxxxxx> wrote: > Your free subscription is supported by today's > sponsor: > ------------------------------------------------------------------- > Is your computer freezing up or slowing down? > Repair corrupt files and harmful errors - protect > your PC > Take a 2-minute PC health check-up at no charge! > caadVJEb7B6Msa/PC > PowerScan > ------------------------------------------------------------------- > > Can I get someone with a 65 or later BB 727 trans to > get a measurement > for me? With the yoke pushed all the way into the > tailshaft (bottomed) > what is the distance from the tailshaft housing (not > the dust cover) to > the center of the U-joint cap? I need this > measurement for driveshaft > fabrication. > > Thanks > Bob H > 63 Fury > > Your free subscription is supported by today's > sponsor: > ------------------------------------------------------------------- > Erase wrinkles without painful injections with > Nexiderm SP. > Nexiderm SP is clinically proven to reduce wrinkles > by 68% Click > here to get your 30-day free supply. > caadVJYb7B6Msf/Nexiderm > ------------------------------------------------------------------- > > ---- > Please address private mail -- mail of interest to > only one person -- directly to that person. I.e., > send parts/car transactions and negotiations as well > as other personal messages only to the intended > recipient, not to the Clubhouse public address. This > practice will protect your privacy, reduce the total > volume of mail and fine tune the content signal to > Mopar topic. Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. > > > George __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com