[AD removed for archives] ------------------------------------------------------------------- Click Here for the #1 Investigative tool on the Net! caadlCpbOyW3Na/Web Detective ------------------------------------------------------------------- well, my whole system is still in progress. but the running the tubes up hill seems to be something everybody agrees on, I guess the theory is that air doesnt have a problem going uphill but water does. As I stated earlier I was also told by these guys at a shop that does air supply systems for mills, "use the biggest pipes u can afford", bigger pipes make drier air, something about less temp shift which i guess is what causes the moisture in compressed air, which I think is basically condensation. Also every low spot in a wall system MUST have a drain, other wise u get a lake at the low spot. I went a step further and actually built my whole system on a slight kilter so theres no flat pipes but a slight tilt to every one leading to a drain. I should have some test results in a couple days, I have one last chunk to finish, then its sandblast time! Neal Zimmerman, Eugene Oregon [AD removed for archives] ------------------------------------------------------------------- Need a Laptop? Get a Sony Vaio Laptop Free! caadlVAbOyW3Nf/ProductTestPanel ------------------------------------------------------------------- ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. bOyW3N.