Finer details needed - drilling flywheel for 360 balance.

[Ray Bell <raybell46@xxxxxxxxx>]

I have the drawing, the dimensions, I even have the 1 13/64 drill and a machine capable of turning it into a flywheel.

But I am curious about one detail. On the Moparts forum when I asked about things John Kunkel posed the question of what angle the drill tip had to be ground to for this job.

Drills of this size usually come with an included angle across the tip of either 118° or 135°, so which is the one to use?

I'm going to a lot of trouble to make a drilling jig so I can do this job properly and so it can be repeated on other flywheels at a later stage and I'd like to have this right.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/48d05244-ca33-46c8-996a-0239994f9dd6n%40googlegroups.com.