[AD removed for archives] ------------------------------------------------------------------- Click here and walk away with your free Chevy collectible. caacDvMb7yoMza/PermissionData ------------------------------------------------------------------- Don't want to sound dumb, but is there any way to easily identify original max wedge exhaust manifolds? Thanks Bob ----- Original Message ----- From: "Bob Fortson" <bobt1885@xxxxxxxxxxx> To: <1962to1965mopars@xxxxxxxxxx> Sent: Friday, September 24, 2004 12:50 PM Subject: Max wedge manifolds... Ok fellows listen up! I have been looking all over America for the source of the "max wedge exhaust manifold reproductions" that were offered for sale at Nationals. Good news and bad news...Bad news is that the ones offered at national for 750 a set are the real deal...except the HOLES ARE DRILLED WRONG...about a .25 of a inch wrong! The good news is that there is a source that is doing these things as repro originals...for the BAD boy engine...expensive as hell (were 800 a pop if you bought 5 sets). My info is from a source on the west coast that asked not to be named for obvious reasons...be carefull ...there is room to wallow out the holes and make them fit but...... Bob Fortson [ [AD removed for archives] ------------------------------------------------------------------- Race to Claim your FREE Stock Car Racing Gift! caacERRb7yoMzf/PermissionData ------------------------------------------------------------------- ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. b7yoMz.