RE: 65 B body drivetrains

[Tom Duross <tduross1@xxxxxxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
caacBBBb7yoMza/MyDietPatches
-------------------------------------------------------------------

I laid both side by side and the yokes are different but the tail shaft
seems the same.
The FSM shows different numbers and lengths but it seems the same to me, or
looks that way.
Well, it's a 65 Belv2 to a 65 Belv2 so even if I use the complete engine,
tranny and driveshaft
all I probably (but I don't think so) have to do is change the rear yoke,
spline, etc.

Thanks Dodger,

Happy Labor Day folks.
Tom


just this morning I tried exchanging drive shafts from these same two groups
of shafts, ( tried to put a 65  273 auto shaft into a 64 318 auto, found
that
the flange bolt patteren was different between them, however they were the
same length, and had the same size yoke)
                                                                  dodger

Dodger-
depending on which cars, they could be different lengths and diameters, not
to mention
transmission and rear yokes.

Tom

[AD removed for archives]
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a 
FREE Cutlery Set + Cutting Board!
caacBBEb7yoMzf/OmahaSteaks
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.