RE: Ken (Headgaskets)

["Westerlund, Ken" <kwesterlund@xxxxxxxxxx>]

===========================================================
Cancel your low-carb diet. Lose weight. Choose your own 
foods. Learn more about our program at:
caaccM7b7yoMza/ Dr. Smith
===========================================================

Hi Don,

Ok, thanks.  I will put them on dry (even if it doesn't feel right).
:-)

I already ran a tap through the bolt holes and cleaned a lot of gunk
out.  

Regards,
Ken

-----Original Message-----
From: Don Dulmage [mailto:big-d@xxxxxxxxxxxx] 
Sent: Tuesday, May 04, 2004 7:58 AM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Ken

Bone dry for the Felpro.
For the old steel head gaskets we give them a light spray of silver
paint just prior to installtion (just a dusting) 
For both torque them in steps. Start at 55Ft Lbs then 65 then 70 and
then recheck the 70 this completely eliminates gasket problems . Also
ifheads have been milled a lot use washers under the head bolts. (if
over .060 has been removed) Sometimes threads in the block are not quite
deep enough and it is hard to tell if the bolt is tight or stuck . This
eliminates the problem.
Don

[Non-text portions of this message have been removed]

===========================================================
Let University of Phoenix make 2004 your year. Evening, 
weekend or FlexNet® classes ? over 130 locations. Look 
into our programs and get the degree that gets you going!
caaccMPb7yoMzf/ UOP
===========================================================



----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.