Re: 440 rod bearing oil holes

[Tom Watters <tomwatters@xxxxxxxxxxx>]

===========================================================
Your opinion counts! We?re conducting a survey for a 
computer service/repair company. When you complete our 
survey, you will also be entered into a drawing for one of 
ten $100 prizes. Just click
caab8K4b7yoMza/ Val Rad
===========================================================
The Cleavite 77 bearings I put in my 440 had the correct oiling holes. 
They were slightly beveled on the backside so it could match the hole
from the cap.

Have a pic? 


On Mon, 19 Apr 2004 09:15:37 -0400, "Westerlund, Ken"
<kwesterlund@xxxxxxxxxx> said:
> I am replacing the rod bearing in my new (to me) 440 and the replacement
> Clevite 77 rod bearings do NOT have the small notch to feed the oil
> squirt hole in the rod cap.  The guy at Summit racing says they are not
> needed.  Am I safe in installing the new bearings?
> 
> Thanks in advance,
> Ken
> 
Tom
65 Dart GT 'vert
68 Plymouth 'vert
Longmont, CO

-- 
http://www.fastmail.fm - I mean, what is it about a decent email service?

===========================================================
Your opinion counts! We?re conducting a survey for a 
computer service/repair company. When you complete our 
survey, you will also be entered into a drawing for one of 
ten $100 prizes. Just click
caab8K1b7yoMzf/ Val Rad
===========================================================
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.