Re: Engine pulling suggestions

[lxpg1@xxxxxxx]

===========================================================
Need to find the right school to fit your needs 
CollegeInformation.info has already found it. Get educated 
on your future ? degrees, financial aid and more!
caab6afb7yoMza/ College Info
===========================================================



In a message dated 4/6/2004 1:26:24 AM Eastern Daylight Time, 
sixtyfourmopar@xxxxxxxxx writes:

> OK so I am a day or two away from pulling the 318 Poly for it's bottom end 
> rebuild.  Anyone have any suggestions/recommendations on pulling the engine - 
> is there anything specific that makes pulling this engine any different from 
> pulling a Chebby 350?
> 
> I just wanna make sure not to screw up anything!
> 
> Thanks,
> 


   All the same. make sure everything is disconnected. Fuel line, exhaust, 
flex plate, motor mounts, hoses, linkage. Should be fairly easy.
Bob

--
[Non-text portions of this message have been removed]

===========================================================
Your opinion counts! We?re conducting a survey for a 
computer service/repair company. When you complete our 
survey, you will also be entered into a drawing for one of 
ten $100 prizes. Just click
caab6Pib7yoMzf/ Val Rad
===========================================================
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.