I am working on a 65 Satellite and the turn signals are not working. I have the proper voltage to the switch in the top of the steering column. I can run a jumper wire from the center power source to the outer points and individually make each side work. So all the wire is good and correct to and from the switch.--The cancelling cam is just a piece of plastic as the 67 and newer have metal tabs on the bottom that make contact when you move the level up and down.What should there be that will make connection from the input source to send output to the lights? Is there suppossed to be some type of metal piece between the piece with the wiring and the top cancelling cam ?Mike
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_ .disclaimer.html
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en .
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@googlegroups.com .
For more options, visit https://groups.google.com/d/optout .
Back to the Home of the Forward Look Network