63 SF Door Cylinder Removal - HELP!

["dennis.1963ply" <dennis.1963ply@xxxxxxxxx>]

I have the door panel off
I have the clip on the cylinder off
I have not been able to get the rod off of the cylinder?

Per the manual page 23-22 :
(3) Withdraw the cylinder part way out of the door panel with a rotating motion of the lock
cylinder body, disengage the lock cylinder arm from from the link.

This sounds simple but I have not been able to get the rod disengaged from the cylinder.
I'll try again tomorrow but if anyone has any suggestions it would be appreciated. 

Thanks
Dennis C.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.