The Poly roared to life last night after being down for rebuild. First time run with the new intake manifold. After a half hour at 1,500 RPM took her around the block a few times. After dinner went a little further and gassed her up. Seems to be doing good, time for some break-in runs......
Thanks for the tip!
Coil location is shown in pic 002 with homemade plate using the bolt holes in the engine head. That pic also shows the Lokar throttle cable and bracket. Have not installed the kick-down cable yet.
That 256 cam from Gary P / Schneider cams most def has some lope to it at idle. And a little push-you-back into-the-seat even at part throttle so far. But then the bench seat springs are 53 years old.... ; )
>The stock cam profile is an anemic 240/.390-.400” (1...@.050”) and the first HP Cam is the Poly 256/.435” (2...@.050”) solid.
http://schneidercams.com/
solidliftercamshafts-11.aspx
Attachment:
DSC_0042.JPG
Description: JPEG image