Re: swapping tapered axles for later flanged axles

Hi fellas and gal,

C body axles are longer for the most part. Moser can shorten and respline axles any length you want as we have an advantage over brand X vehicles. Mopar axle shafts are larger in diameter towards the flange end. The distance to watch out for will depend on center section used. There is a difference in thrust block thickness through the years.

Mike LeFevre

On Thu, May 7, 2015 at 9:31 PM, Ray Bell <raybell46@xxxxxxxxx> wrote:

There may be a standard axle shaft that will fit the '64 rear axle housing, perhaps from a C-body, but the earlier axles you will not match up. Aftermarket axles are now available, maybe someone could shorten and re-spline pickup axles to suit.

The lengths are critical, of course.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.