Poly 318 engine specifics (Was Re: NO SUBJECT)

["Gary H." <62to65mopar@xxxxxxxxxxx>]

I'm putting a subject description on this discussion thread to keep better track on the topic.

Thanks,
Gary H.
'62-'65 Admin.


>  -------Original Message-------
>  From: tothperformance 
>  
>  We have 1.94 and 2.02 intake and 1.60 exhaust stainless valves available.
>  They are 3/8 stem 45 degree seats.
>  
>  
>  --------------------
>  
>  FROM: "'Stan Kafouse'  
>  
>  
>  What size valve do these engines run? Has anyone tried a 11/32 stem or 5/16
>  stem valve or a 30 degree seat?
>  
>  
>  On Thursday, January 8, 2015 4:50 PM, "tothperformance  wrote:
>  
>  
>  The heads flow 254 cfm at this point I feel be close to 270 cfm when we are
>  done with the R&D. Roller cams are a custom order. However we have new flat
>  tappet solid cams available for $299.00, New lifters are $129.00.
>  
>  Bruce Toth


>>'Stan Kafouse'
What do they flow at 300? They flow 260ish at what lift? So these engines will only make the power 260ish will allow.   what about torque?  So no matter what, naturally aspirated these engines are flow limited  to around 400 or so hp? Just trying to educate myself on these engines. Thanks

>> 'Stan Kafouse'
Just out of curiosity what size are these poly engines (motors are electrical devices) being built?  How much torque is made and what do the heads flow when ported?  Can you get an off the shelf roller cam or is that a custom deal?  There are a lot of poly engines in my area (southern ga.) if anyone is in need of one.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/d/optout.