Carb Spacer

[Doug J <63sprtfury@xxxxxxxxx>]

Wondering what if anything you guys are running for carb spacers ?  I had what I think is the stock "fiber" like spacer until I changed carbs a few years back.  Went with the phenolic spacer.  I seem to have a hard time keeping this sealed or it might have a small crack. 

Anyway, looking for recommendations for spacer and type of gaskets to use for a good seal.

This is a 68 383 Road Runner engine with stock cast iron intake and edelbrock carb.

Thanks

Doug

'63 Sport Fury ragtop

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.