Re: Carb Linkage

["'Paul L. http://1962to1965mopar.ornocar.org/ml-lennemann63.html' via The 1962 to 1965 Mopar Mail List Clubhouse" <1962to1965mopars@xxxxxxxxxxxxxxxx>]

As far as the distributor goes you need to get #1 piston to top dead center on the compression stroke (piston all the way up and both valves closed) then install the distributor so the rotor points to the #1 spark plug lead.  Been quite a few years since I had a poly so can't tell you right off which tower on the distributor cap should be used for #1.  But there are plenty of guys here that can.

Paul L.

On Sunday, September 14, 2014 11:13:36 PM UTC-5, Bubba wrote:

Will the original 2bbl carb linkage on a 64 Fury 318 poly fit the Edelbrock 4bbl Performer 1405 carb?

 

I just installed the 1405 carb on my Fury and the accelerator linkage and return spring set-up seem to be wrong (short linkage).  It appears that I can drill the carb accelerator link setup to accommodate the Mopar pedal ball link, but things seem short to reach the 4bbl in a correct manner.

 

If it needs to be changed or "fixed", what has everyone done to make it work?  I am anxious to get this engine started and broken in ASAP.

 

Also, since the distributor has been out of the car, what is the easiest way to sync the distributor to the engine to get it close enough to get the car to start?

 

Larry

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.