OK - Originally, I posted and asked if any actually knew for sure if it was possible to exchange 63-64 tapered axles for 65 up flanged axles in my 8 3/4 741 case with 3.23 sure grip. I need to install a 4.10 Sure grip. Do the 63 and 66 Axles have the same axle housings? Can I swap in the complete 66 Axle assembly IF I use the correct length axles?--So far, I have learned that:- it IS NOT POSSIBLE as bearings are different- it IS POSSIBLE and a simple swap if all compatible parts are used- Green bearings suck,- Green bearings do not suck- Its easy to replace Wheel Studs,- Its easy to upgrade brake drums,- the spacers in early and late sure grip units are differentSo far no one has offered any advice from personal experience concerning the exchange of tapered axles for flanged axles and what is needed for the swap......Does anyone have an empty 53-64 8 3/4 housings to examine for fitting green or stock adjustable bearings? Are the bearing retainer plates the same between 63-64 and 65 up?
On Thursday, August 28, 2014 11:59:29 AM UTC-7, Dennis C. wrote:There has been a couple of discussions about tapered axles, replacement of complete differentials and such. This may have been covered but here is a very good article describing how to convert from a tapered hub / brake drum unit to a standard brake drum. Much easier to service and less expensive.
This is also a good time to change over to standard studs if you are still running the left handed studs on the left side.
http://hotrodsandhemis.com/PolaraRearBrakes/TaperedAxleBrakes.html
Dennis C.
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.
Back to the Home of the Forward Look Network