|
Hey y'all. Going out of town until Monday but got a question for the group. Is there any way to determine what size cam I have in my 440 without taking it apart. The reason I don't know what size cam I have is that I bought the motor from a guy who needed money for an operation. He said he put in a cam "a size or two above the factory" but did not remember what grind. Plus he re0 ringed it. He said he used the original pistons. The block is a 1970 casting. The reason I ask this is cuz I'm trying to find the best matching intake for my car.
-- Here's what I got. 65 Polara with above engine and a rebuilt 727 tranny with the stock torque converter. 3.23 gears with 245/60/R15's on the front, and 255/60/R15's on the back. The car is 100% original except for the tranny, engine and tire size. The original tire size was something like 195/75/R14. Damn car would lay 50 foot patches of rubber no problem with those little things on there. I've wanted to ditch the cast iron boat anchor for a while now but haven't had the money until now. And I want to do it right the first time instead of being unhappy with my choice of intake. So yeah, I need some serious advice with this. Or should I just pick an intake and be done with it. What I really want is some more low end grunt without sacrificing my top end. I know the much larger than factory tires will make my gear ratio closer to a 2.97 or so. As I said, I don't want to be unhappy with my choice of intake. So any help would be much appreciated. Thanks in advance. Cory -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/groups/opt_out. |
Back to the Home of the Forward Look Network