65 Satellite ignition lock

["Gary H." <62to65mopar@xxxxxxxxxxx>]

I'm forwarding this email that came only to me instead of all. 

My answer is: 

Do you mean remove the lock cylinder from the switch? 

I don't recall if '65 is the same but on some Mopar switches there is a small brass pin you can see in the front. 
Turn the key to the position that allows the brass pin to be pushed down with a small punch or paper clip.
Wiggle cylinder until it frees out. 

Thanks,
Gary H.


>  -------Original Message-------
>  From: gto64gto 
 
>  I found a NOS matched lock set. I have replaced the door cylinders. I can
>  take the ignition switch out but I don't know how to remove the key section
>  from the ignition switch. Can anyone help? Thanks so much.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.