IIRC. I used this type on my engine. Evidently the
heads had been milled enough that I couldn't use all the recommended
gaskets. I just used the thinner paper gasket on the intake side and
sealer. Just barely got the bolts in the intake man. bit I think it is sealed up
well......................MO
----- Original Message -----
Sent: Wednesday, February 05, 2014 7:43
PM
Subject: Re: intake manifold Mopar big
block install?
Gary,
There was some trouble getting the aluminum six barrel intakes to seal
properly when they came out so the paper gaskets were introduced. I've used
them with and without successfully. I suppose it was machining
tolerances from Edelbrock causing the trouble but you didn't hear that from
me. There is no reason the factory tin gasket couldn't be used
indefinitely over and over if new paper gaskets were used every time. I like
to use some sealer like comes with tin gasket from Felpro or Hi Tack sealer on
the port area and silicone on the ends to seal everything.
Mike LeFevre
-- -- -- Please address private email -- email of interest
to only one person -- directly to that person. That is, email your parts/car
transactions and negotiations, as well as other personal messages, only to the
intended recipient. Do not just press "reply" and send your email to everyone
using the general '62-'65 Clubhouse public email address. This practice will
protect your privacy, reduce the total volume of mail and fine-tune the
content signal to Mopar topic. Thanks! 1962 to 1965 Mopar
Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html
and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. --
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. ---
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from
this group and stop receiving emails from it, send an email to
1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out.
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.
|