Intake bolts

[PallCon Services <pallconservices@xxxxxxxxx>]

I started to assemble headers and intake this weekend but found 3 different length Allen hex bolts from the tear down. With new aluminum heads I want to make sure I use right bolts. Can anyone tell me what length bolts used to bolt the 426 cross ram intake to the heads? Are there two different lengths? 3 of each ?
Also where can I buy the  6 intake plugs that cover the bolt holes
I had the intake powder coated so I don't want to use the old rusty plugs if I don't have to 
Thanks for any help.
David



Sent from my iPhone
PallCon Services

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.