Re: Adjusting/Lubing 65 Floor Shifter Linkage/Cables

[Bob <64ragtop@xxxxxxxxxxxxx>]

Like Gary said, disconnect the cables at the shifter, then if it's a 
shifter problem it will be obvious.  Repairing that should be fairly simple.
If it is the cable, you'll need to disconnect them from the tranny and 
either clean and lube or replace them.  New cables are available.
I think releasing the cables from the trans is like my '64ragtop.  I can 
send the stuff relating to that from my manual if you need it. A '65 FSM 
would be mighty handy.

BC



On 5/31/2013 8:08 AM, Gary H. wrote:
> I'd disconnect the cable at the shifter and test the movement of the cable and the shifter independently. Odds are it is a cable issue.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.