Re: Ignition up grade

[John deVries <corneliusdevries@xxxxxxxxx>]

Thanks everyone for you advise. I have rebuilt my point distributor. So I think I'm going to throw flames. I have the older version in my MG. It let me down several times but it was the blaster coil and the ballast resistor cutting the voltage to low for the system to run. Have the flame thrower coil in it and it runs fine. I wish I had the money to go MSD. Like some I will spend hours fixing a old part over buying new. Partly for the satisfaction of making it work and not having the resources for new. I will leave opening a catalog and buying a new car to the Chevy guys. You will find me in the junk yard picking and pulling. 

Sent from John

On Mar 4, 2013, at 7:22, Bill M <y1topbanana73@xxxxxxxxx> wrote:

> I would personally recommend that you carry an extra points
> distributor with you so you can swap it out if needed. I've been left
> stranded by mine at least 3 times and will not run it anymore. Some
> people have great luck with them...just make sure you have AAA if you
> do!
> 
> Bill M
> 65 Coronet 500 'vert http://goo.gl/6xUS1
> 73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
> 21 Model T Depot Hack, 06 Mazda 3
> 
> 
> On Sun, Mar 3, 2013 at 9:37 PM, mabendaspoor <deltamin@xxxxxxxxxxx> wrote:
>> I installed the Pertronix complete distributor plus flamethrower coil and
>> removed the ceramic resistor about 15 months ago. Not a single days'
>> problem.
>> 
>> 
>> On Sunday, March 3, 2013 10:52:52 PM UTC+2, john1964 wrote:
>>> 
>>> Want to upgrade my stock 318 poly distributor. Was leaning toward the
>>> Pertronix ignitor II and their flame thrower coil. Looking for the groups
>>> input.
> 
> -- 
> -- 
> --
> Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> -- 
> You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> http://groups.google.com/group/1962to1965mopars?hl=en.
> 
> --- 
> You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
> For more options, visit https://groups.google.com/groups/opt_out.
> 
> 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.