|
Gary did a good job on the ID, I will add a few comments,, this same
casting was used from 62-65 for 413 and bored to the 426 as well,,,,, It was not
the casting used for the max wedges,,,,,413 and 426 pistons are almost double
the 440 pistons, and you will find it argue able as to if it can be bored to
take the cheaper 440 pistons, as for he HP stamp, that is all it is, the
internals and block itself are the same as other blocks without the stamp,
and the extra value of the block is the stamp,,,,,, it will or did have the
forged crank in it which most 440 builders are looking
for,,,
-- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out. |
Back to the Home of the Forward Look Network