On Sun, Oct 21, 2012 at 7:22 PM, neal zimmerman
<neal.zimmerman@xxxxxxxxx> wrote:
hi all, i hear tell that preheating lets welds sink in easier, and
supposedly is less stressful on the metal when its cold. so my new
shop is unheated,and heating it is not a possibility, financially or
physically. It gets somewhat cold here in Oregon in the winter, not
like Wisconsin cold, but cold enough that the metal wouldn't like it.
lets say i want to weld in some sub-frame connectors. my idea is cut
them perfect and set them on the wood stove to warm , and heat the
underside of the car with a couple halogens. would that do it or do i
need to go much hotter to do any good, , as in an oxyacetylene setup.
or how about heating the underside with a torpedo heater. would that
do it? i don't have an oxy setup and cant afford one.
Neal Zimmerman, Eugene Oregon
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network