RE: Intake

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Yes.

Seems I remember an Edelbrock carburetor. Per Don D's formula "a 318 needs 318 X 2 which is 636 cfm so a 650 would be perfect for a screamer and a 600 for a grunter (truck, etc.)"   As he wrote:  "It is the low speed performance that we are always concerned about and the carb sizing formulas....picking the largest size of carb practical that will still drive normally and properly at normal low speed so you can use the same formula even if you intend to drive like yer Granny."

Maybe Gary P. can provide a carb model number suggestion. 

Thanks,
Gary H.
 
>  -------Original Message-------
>  From: Bill Paxton  
>  
>  Are these all factory intakes? Which would be able to use the best available carburetor? I'm looking for a single 4 barrel unit.
>  Thx
>  
>  -----Original Message-----
>   
>  
>  Casting number 1822004 is what I see,  for two 4 bbl. WCFB carburetors
>  
>  Also:
>  
>  1619826 WCFB 4 bbl. carburetor
>  
>  1859229 AFB 4 bbl. carburetor
>  
>  2206384 AFB 4 bbl. carburetor
>  
>  Thanks,
>  Gary H. 

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.