Re: Re: front window vent question

[Mike & Deb <mdlefevre@xxxxxxxxxx>]

Hi fellas and gal,
The slot in the vent latch is indeed for a screwdriver since the slotted piece is a nut. The carriage bolt is threaded and it and the slotted nut hold the inner and outer chrome trim pieces together, sandwiching the glass. Joe Suchy stocks new rubber gaskets for the trim pieces.I completely disassembled the vent assemblies on my 65 Belvedere and subsequently purchased excellent used assembles from one of our female members (gal). I have parts if anyone needs them. The upper pivot male half is riveted to the steel frame that receives the gasket. That frame is screw fastened to the chrome zinc main assembly frame. Are you guys following this? The male pivot is steel and the female is also a zinc casting so you can't put much heat on for disassembly. While I had mine out I relined the glass run with new fuzzy stuff-glued it in with GOOP. To do a comprehensive job the assembly must be removed. Lots of work!
Mike LeFevre

On Jul 24, 2012, Gary H. <62to65mopar@xxxxxxxxxxx> wrote:

Lubed and letting it sit.

No I am not trying explicitly to save the glass; it is good. But I don't want to mindlessly smash it, if possible. :)

Thanks,
Gary H.


> -------Original Message-------
> From: Gary Wilson
>
> Not that I remember.   I think that you have to lube the bolt and just
> keep working it until it comes out.  Are you trying to save the glass or
> is it bad or missing.?

--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.