I was told by Jim @ Racer Brown that the Hemi Super Stock Scoop should have the back edge of rht scoop flush to the back edge of the hood. Thius was derived directly from a factory car that he owned. Templates-If someone can get measurements, I can re-create the template in CAD and print them. I have the ability to print on paper up to 36" wide. Bill M 65 Coronet 500 'vert http://goo.gl/6xUS1 73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie 21 Model T Depot Hack, 06 Mazda 3 On Mon, Jul 9, 2012 at 4:13 PM, Gary H. <62to65mopar@xxxxxxxxxxx> wrote: > http://books.google.com/books?id=J7MfGlCt1DEC&pg=PA94#v=onepage&q&f=false shows a technique for putting a MW scoop on an A body hood. > > The larger scoop is a Hemi engine scoop. > > Did you talk with Jim Kramer at Carlisle? He sells a MW style scoop and should have a measurement. > > We (the '62 - '65 mail list) used to have a paper template to use but it got lent to someone who never returned it. Seems like it is time to get this issue nailed again, as the question comes up over and over as to position of the scoop. > > Gary H. > -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.