|
I usually fill mine to within an 1/8 inch of the gasket surface area, a new
gasket may be a problem, you might check the Help area at your local parts
store, the gasket is not normally a problem for leaks
In a message dated 7/4/2012 12:54:18 P.M. Central Daylight Time,
noble_leslie_devotie@xxxxxxxxx writes:
I have manual brakes on a 65 Dodge Coronet. When I took the cap off the brake cylinder the fluid is not quite up to the post that the cap screws into. How full should this thing be? Should it be almost full such that it would go above the post? On a semi-related note, the gasket inside this thing is kind of beat, but I could not find any replacement gaskets online. Anyone have a source for these? -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |
Back to the Home of the Forward Look Network