Re: Poly Block Update-Not So Great

[Bill M <y1topbanana73@xxxxxxxxx>]

Bad news the major wear he was talking about is on the rear THRUST
surface of the #3 main, although the bearing surface of the block and
cap are a bit chewed too.

Are the oversize bearings oversized on the thrust surfaces too? Is
there a specific measurement for how thick the block and cap should be
at the thrust area?

Not sure how to proceed with this one.

Bill M
65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
73 Dart Sport, 00 Cherokee Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
21 Model T Depot Hack, 92 Accord, 06 Mazda 3


> In a message dated 1/4/2012 8:28:54 P.M. Central Standard Time,
> raybell46@xxxxxxxxx writes:
>
> There are undersize bearings and there are oversize bearings.

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.