4 speed tranny mount / crossmember

[MO <micher@xxxxxxxxxxxxxxx>]

To Gary H and anyone interested , here is a link http://62to65mopar.shutterfly.com/
that shows my correct 1964 Dodge rear trans mount. for a 4 speed  I
could not find my auto trans mount for comparison. . Note that the top
plate is fairly thin and the square hole is centered front to back and
side to side. . the two holes on each side of it  are to access the
two bolts that goes in the tailshaft housing mount pad. The square
hole at the top and the two studs that go through the bottom are all
that secure the rubber isolater.

Gary, you may use this info as you wish............................MO

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.