Electronic ignition conversion

[Doug J <63sprtfury@xxxxxxxxx>]

Hi all.
Been needing to replace the old distributor in my 63's 383, so I went
digging through my old parts and found an electronic distributor, a
couple control boxes, and the wiring harness for a conversion system.
What I am wondering, is what I need for a ballast resistor, and if I
need to change the voltage regulator as well?  Been awhile since I
messed with these things !
Thanx

-- 
Doug,
'63 Sport Fury 'vert

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.