Re: How do I get the front cylinders out?

Not sure if I understand you (upper and lower?), but brake cylinders are held on with two amall bolts from the back side of the backing plate. Does that help?

Dave
'64 Belvedere 2DHT
318 Poly, Push Button Auto
Originally Florida A/C Car

From: Eric R <hoodoovoodooray@xxxxxxxxx>
To: The 1962 to 1965 Mopar Mail List Clubhouse <1962to1965mopars@xxxxxxxxxxxxxxxx>
Sent: Monday, October 10, 2011 10:29 AM
Subject: How do I get the front cylinders out?

I need to replce the upper and lower. I took of the drum and four
bolts, but the metal plate in the center of all the brake hardware
still holds the cylinders. How do I remove that plate, I don't see
any obvious way?
Thanks.

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.