You are right but this is not a new engine. Only the heads and cam are changed. The cam will break in before the parade so all is well there. It's the same short block that has been in the car since '06. It doesn't have many miles on it though. I just cleaned it up and checked it out.But yes a parade would be a disaster for a fresh engine. The time of year, hot, and the conditions, extremely slow, really test your cooling system! My potential problem is that the tune will be off for the new combo. I don't want to run lean and fry it.Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies======================================================================================================================================On Tue, Aug 16, 2011 at 8:50 PM, Jay <shelby_nut@xxxxxxxxx> wrote:
Isn't a parade probably the worst way to break in a new engine? I'm no master engine builder but if I recall part of the break in procedure is varying the rpm's, loading and unloading the engine, etc to help seat the rings, putt putting along in a parade at extreme temperatures (your engine going to run even hotter with a fresh, tight rebuild) is probably not a great way to do it...I hope you'll be doing the following (or your preferred variation) on Friday...1. Always bring engine to FULL operating temperature before high revs.
2. Drive the car easy for the first 10 miles or so, varying the rpm's from 2,000 - 5,000.
3. Then, start bringing the engine up to maximum rpm's and letting the engine bring the revs back down by coasting in gear (vaccum pulls).
4. Repeat several times in order to create maximum heat in the cylinders.
5. Drive around at lower RPM's for several more miles, remembering to vary the speed of the engine every couple of miles.
6. Repeat number 3, 4 and 5.
7. Park car and let the engine cool down overnight.
8. Repeat all the above 2 more times.(This is just a break-in procedure I found on the net from a 35 year engine builder, they all seem to have there own variation but the concept is similar, varying speeds, varying loads)Jay
From: Richard Kinsley <leroar.kinsley058@xxxxxxxxx>
Subject: Short block installed
To: 1962to1965mopars@xxxxxxxxxxxxxxxx
Received: Tuesday, August 16, 2011, 7:48 PM
Today with the help of Dodger and Terry Bohnart I got the short block in place on LeRoar. Everything is going fine. Next Sat, Aug 20th is the Bellevue parade. I am trying to get it ready for the parade. The heads are due to arrive on Thursday. I will install them in the car. I won't have much if any time to tune so I hope it is close enough. A parade is the most severe test you can have for your cooling system. I'll keep my fingers crossed.Also Dodger told me our 1/8th mile track is gone forever. The flood wiped it out and the health dept won't let them rebuild unless they replace the soil as it is supposedly contaminated by sewage from the flood.
--
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.