Subframe connectors

[Mike & Deb <lefevre@xxxxxxxxxx>]

I installed connectors last summer on my 1965 Belvedere 2 Dr Hdtp. that 
I fabricated from 2" square tube. I just made a pattern of the curved 
front of the rear frame stubs and cut it out. Then measured and cut to 
length. Upon fitting I found an area approximately 6" long that had to 
be cut out of the rear foot wells for clearance and when installed I had 
less than 1/4" above the floor to weld in. I did the install before 
removing and replacing the floor pans. Did the same install on my 1966 
Belvedere wagon and cut slots for the parking brake cable to pass through.
Mike LeFevre


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.