Re: valve springs

[Roger Pettigrew <dodger7998@xxxxxxx>]

yep you can even make your own tool if  you want,,,,,,,   I prefer to use 
cotton rope instead of air
 
 
In a message dated 10/27/2010 6:27:54 P.M. Central Daylight Time,  
micher@xxxxxxxxxxxxxxx writes:


Tech  question--On a chebrolay you can change valve springs without 
removing 
the  heads by using a simple tool. and air pressure in the cylinder to keep 
the  valves closed. ---Is there a way to change valve springs without 
removing  the heads in a Mopar 440 engine?  Thanks for any  
help................................MO
{Steve  Mick}
http://stevemick.shutterfly.com/pictures#Part%202  


----
Please address private mail -- mail of interest to only  one person -- 
directly to that person.  I.e., send parts/car transactions  and negotiations as 
well as other personal messages only to the intended  recipient, not to the 
Clubhouse public address. This practice will protect  your privacy, reduce 
the total volume of mail and fine tune the content signal  to Mopar topic.  
Thanks!

1962 to 1965 Mopar Clubhouse Discussion  Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and  
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.  




--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.