Re: 750 Holley

[Jeff <chargr1969@xxxxxxxxx>]

from all the info i have been reading about your problem. i would have to say something is not right with the carb. i would take it back apart. just my thoughts.            jeff















--- On Thu, 9/16/10, William Harrison <bbjt3@xxxxxxxxx> wrote:

> From: William Harrison <bbjt3@xxxxxxxxx>
> Subject: Re: 750 Holley
> To: 1962to1965mopars@xxxxxxxxxx
> Date: Thursday, September 16, 2010, 2:01 AM
> I swapped from a 650 Edelbrock to the
> Holley.
> I had the throttle and kick down loose and started the
> motor and high rev instantly.
> How do you use the propane?
> Open the valve and wave it around the base and vacuum
> openings?
> 
> Later
> Bill
> 
> --- On Wed, 9/15/10, Nico Over <nover@xxxxxxxx>
> wrote:
> 
> > From: Nico Over <nover@xxxxxxxx>
> > Subject: Re: 750 Holley
> > To: 1962to1965mopars@xxxxxxxxxx
> > Date: Wednesday, September 15, 2010, 4:41 PM
> > 
> > Bill were you running another carb on this engine and
> just
> > swapped to the new 
> > 750 and this condition appeared? Also does it run away
> with
> > no throttle hooked 
> > up? If it is a vacuum leak I use propane to find them.
> Hope
> > this all has not 
> > been addressed previously, am late to the party on
> this
> > one.
> > Nico Over
> > Va. Beach, Va.
> > 63 Dodge 330
> > 64 Plymouth SF
> > 65 Bel II vert
> > 
> > 
> > ----
> > Please address private mail -- mail of interest to
> only one
> > person -- directly to that person.  I.e., send
> > parts/car transactions and negotiations as well as
> other
> > personal messages only to the intended recipient, not
> to the
> > Clubhouse public address. This practice will protect
> your
> > privacy, reduce the total volume of mail and fine tune
> the
> > content signal to Mopar topic.  Thanks!
> > 
> > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> > http://www.1962to1965mopar.ornocar.org/mletiq.html and
> > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> > 
> > 
> >
> 
>