Do it everytime with the 727 on my 440 powered '65. Last time, I pulled the hood off to make it easier. Used masking tape and a marker to index the hood to the hinges so it goes back togehter in proper alignment. Akron Don Gallimore ----- Original Message ---- > From: Jimmy Peavy <peaver63@xxxxxxxxxxxxxx> > To: 1962to1965mopars@xxxxxxxxxx > Sent: Sun, September 12, 2010 8:32:06 PM > Subject: Re: 62 engine bay slip-in-ability ( !!!) > > > I dropped a Hemi in one, and a 440 in one, with the balancer on. > Just took the hood off. > > On 9/12/2010 7:26 PM, Neal wrote: > > Anybody ever slipped an RB engine with attached 727 TF into one of the > > 62-65 b-bodies all in one piece??? I would like to do it if > > possible. Of course I would have the hood off, front tires > > deflated,balancer off, etc, Just want to know if its do-able at all. > > neal zimmerman, eugene oregon > > > > > > ---- > > Please address private mail -- mail of interest to only one person -- >directly to that person. I.e., send parts/car transactions and negotiations as >well as other personal messages only to the intended recipient, not to the >Clubhouse public address. This practice will protect your privacy, reduce the >total volume of mail and fine tune the content signal to Mopar topic. Thanks! > > > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > > http://www.1962to1965mopar.ornocar.org/mletiq.html and >http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > > > > > > ---- > Please address private mail -- mail of interest to only one person -- directly >to that person. I.e., send parts/car transactions and negotiations as well as >other personal messages only to the intended recipient, not to the Clubhouse >public address. This practice will protect your privacy, reduce the total volume >of mail and fine tune the content signal to Mopar topic. Thanks! > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html and >http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > --^---------------------------------------------------------------- > This email was sent to: dongallimore@xxxxxxx > > http://topica.com/u/?bUrDWg.caU2BH.ZG9uZ2Fs > Or send an email to: 1962to1965mopars-unsubscribe@xxxxxxxxxx > > For Topica's complete suite of email marketing solutions visit: > ?p=TEXFOOTER > --^---------------------------------------------------------------- > >