RE: Just Suspension

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

Brian,
	I understand your frustration but have a question... once assembled
will there be any possibility of the boot popping loose from the joint?
Unless I'm mistaken there would be sufficient compression of the boot to
keep it seated on the joint, or am I reading this wrong?

SC 

-----Original Message-----
From: Brian Safford [mailto:hzf9vv@xxxxxxxxx] 
Sent: Monday, August 09, 2010 4:14 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Just Suspension


Well, this is pretty bogus in my opinion.

The driver's side tubular control arm / ball joint I received from Just
Suspension didn't have enough of a lip on it to properly hold the rubber
boot. I had no problem at all with the passenger side assembly
- at least 1/8" or better there.

So I called them about a month ago and complained, and they were very
apologetic, understood exactly what I was saying, and agreed to send me a
fully assembled replacement as I didn't think I should have to assemble it
myself given it was their issue.

The replacement showed up today ... with less than 1/16" of lip for the boot
- same problem as before, not enough surface friction to hold it on when the
ball joint moves much past vertical.

So I call them again ... again, very apologetic and understand why I'd be
upset, but you know, since these are such low cost control arms you just
have to accept the fact that there will be production variances outside of
their control ...

Wow.

They agreed to send me a FedEx label so I can ship it back at no cost and
get a full refund.

Here's my question to you folks ... do you think I can take the one I have
to a shop ( or just grind it myself ) and grind off enough of the ring so
the boot will fit better without causing any strength or reliability issues
to the control arm assembly?

I'm also considering cleaning off my original equipment control arms and
installing them instead.

Last piece of business I will *ever* do with Just Suspension.

Regards,
Brian Safford
'62 Dart 440 / Poly 318


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.