RE: Rim/tire width

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

According to the BFG TA tire chart, the wheel should be 7.5"-9.5". You 
stand the risk of rolling it off the bead if the pressure is too low or 
maybe you go a bit too fast around a corner. You won't be protruding at 
all over the rim.

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
===================================================================== 
Jeff Adams wrote:
> 
> I just got a new set of those Halibrand copies from Jegs yesterday, but 
> I don't like the fact that the front and rear rims look like the same 
> offset, even though the fronts are 7" and the rears are 8". What I'd 
> like to know is if anyone has ever mounted a 275/60/15 tire on a 10" 
> wide wheel? If so, how much tire bulge was there? Right now those tires 
> are mounted on a pair of 8.5" Torguethrusts and they bulge 1" at the 
> face and rear.
> 
> Jeff Adams
> 64 Polara



Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.