RE: 62 to 65 4 Dr. to 2 Dr. conversion

[Bill <hemirr@xxxxxxxxxxx>]

I'm still working on one of these too, a '62 Plymouth, I will say that once you start getting into the two door parts and removing them (I removed plenty of extra figuring to trim later as needed) it will start becoming pretty obvious how to proceed.  The 2-door quarter filler or slug that goes in where the 4 door back door fits is actually held in the body shell across the top by sheet metal screws from the factory...

Bill & Kathi Parker, South Central Indiana '62 Plymouth Max Wedge; '64 Dart convertible; '65 Barracuda \6; '65 Imperial; '68 Barracuda FB 340-S; '69 Barracuda FB now 360; '70 Challenger now 440; '72 Cuda '340



 		 	   		  
_________________________________________________________________
The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail.
http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.