Super Stock Spring Hangers

[Dave64 <lt7dave@xxxxxxxxx>]

I'm in the middle of my rearend and spring swap on my '64 Belvedere.  I have the 2" front spring hanger brackets that go with the SS springs, but the studs don't line up exactly right with the holes on the car.  There are 4 studs.  When I compare them to the stock hanger brackets, they line up correctly side to side, but the top to bottom is off by about 1/8".  I'm thinking about drilling out the holes just enough to get them to fit - there's no way they'll fit otherwise.  Anyone else experience this?  

Dave


      


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.