Re: U-joints
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: U-joints



${top_text_ad}
Merwin,

You can buy an "adapter" u-joint (I don't remember the part #) that
will go from "big" to "small" yoke. I know Napa has them listed, but
you'll have to get someone that's willing to look for it.

Put that in and you're golden.

-- 
Bill M
65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
73 Dart Sport, 00 Cherokee Sport, 01 Dakota SLT
21 Model T Depot Hack, 92 Accord, 06 Mazda 3

On Mon, May 17, 2010 at 2:42 PM, Merwin Wrisley <vulcan@xxxxxxxxxxxxx> wrote:
>
>
>    I changed the rear end unit in my '65 Coronet, and discovered the yoke was bigger than
> the one on the unit I pulled out, it is about 1/2 inch wider. It appears that I'm going to use a different sized u-joint, has anyone run into this? I can't change driveshafts due to the ball & trunnion on the front end. Any information will be greatly appreciated,    Merwin

${bottom_text_ad}
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.

This email was sent to: ${recipient}

u/?bUrDWg.${encoded_sub_id}.${EMC}








Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.