Re: testing steel wheels?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: testing steel wheels?



tap them with a hammer a cracked rim will not have the same dong 

--- On Wed, 2/10/10, MO ( Steve Mick) <micher@xxxxxxxxxxxxxxx> wrote:

> From: MO ( Steve Mick) <micher@xxxxxxxxxxxxxxx>
> Subject: Re: testing steel wheels?
> To: 1962to1965mopars@xxxxxxxxxx
> Date: Wednesday, February 10, 2010, 1:13 AM
> 
> Gary, you could take them to a shop that does spin
> balancing. Chuck them up and spin by hand to check for side
> to side wobble and check for out of roundness.  If
> there are no cracks, they should be OK unless the buyer
> mounts radial tires and installs on a heavy vehicle. Then
> they may crack ..........................MO
> ----- Original Message ----- From: "Gary H." <spigot2039@xxxxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Tuesday, February 09, 2010 5:21 PM
> Subject: testing steel wheels?
> 
> 
> > 
> > Hi all,
> > 
> > I'm going to ship 2 plain stock Mopar steel wheels
> (without tires) to a fellow in Europe. I assume these 1962
> Plymouth B 14" wheels are okay, but is there a way to test
> the wheels to see they are not bent or unusable before I
> send them?
> > 
> > I'd hate to learn the wheels were bad after all the
> cost and effort to get the wheels shipped over the Atlantic
> pond.
> > 
> > Thanks,
> > Gary H.
> > 
> > 
> > ----
> > Please address private mail -- mail of interest to
> only one person --  directly to that person. 
> I.e., send parts/car transactions and negotiations as well
> as other personal messages only to the intended recipient,
> not to the Clubhouse public address. This practice will
> protect your privacy, reduce the total volume of mail and
> fine tune the content signal to Mopar topic.  Thanks!
> > 
> > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> > http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> > 
> > 
> 
> 
> ----
> Please address private mail -- mail of interest to only one
> person -- directly to that person.  I.e., send
> parts/car transactions and negotiations as well as other
> personal messages only to the intended recipient, not to the
> Clubhouse public address. This practice will protect your
> privacy, reduce the total volume of mail and fine tune the
> content signal to Mopar topic.  Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> 
> 
> 





Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.