Use a vacuum gauge to find maximum engine vacuum when turning the screws at idle
Dave Isle wrote:
Ok first off guy and gals can you read this I'm sending it on my blackberry because my computer is down. Anywhoo I have a 361CI with a stromberg? or Is it a Rochester WWC two barrel my question is does anybody know what the float level should be, and how many turns out should the idle mixture screws be? Mine is. 1 1/4 on one screw and 2 1/8 turns on the other any help will be greatDave Sent via BlackBerry by AT&T ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.