Re: rocker arms
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: rocker arms




My guess is the 440 Source aluminum roller rockers are imported. Haven't had any problems with them.
 Akron Don

Steven Charette wrote:
MO,
	It's one of those things you'll have to check when you assemble the
engine.  I've used Cast Iron rockers and had the adjusters hit the baffle at
.590 lift, but aluminum rockers didn't hit with the same cam and pushrods.
Years back I had a set of 4 bolt valve covers and the adjusting screws hit
the baffle.  The dings in the baffle made a great center mark and I drilled
each one with a 3/8" drill which eliminated the problem.  You could always
use a thicker gasket or double up good quality gaskets for extra clearance.

	I've heard the same as Joey, and recall Mancini advertising a set of
aluminum rockers with the caution that they could not be used for lift over
.480".  Also heard stories of some of the imported rockers coming apart at
inopportune times, but have never seen it firsthand.

	Anybody had experience with the imported rockers?

SC

-----Original Message-----
From: MO ( Steve Mick) [mailto:micher@xxxxxxxxxxxxxxx] Sent: Saturday, December 12, 2009 1:59 AM
To: 1962to1965mopars@xxxxxxxxxx
Subject: rocker arms


I am going to use 440 heads with stock valve covers.. Can someone tell me if
I will have V cover interference with  a .500+ lift cam  and roller tip or
aluminum rockers? (1.5 ratio )...........Thanks for any
input..................................MO

----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.





----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.