Re: '65 Sat. rocker mldg. pic/info needed

[Donald Gallimore <dongallimore@xxxxxxx>]

The rocker panel moulding on a '65 satellite is about 3 1/2" to 4" wide and has three or four horizontal stripe indentations in it. The Belvedere II has a piece about 3/4 to 1" wide.  

Sorry, photos are on my home computer.  I have extra molding but they all have one hole in them in the front to attach them to the body to make up for an apparently rusted out front clip.

  Akron Don




________________________________
From: "dwalters@xxxxxxxxxxxx" <dwalters@xxxxxxxxxxxx>
To: 1962to1965mopars@xxxxxxxxxx
Sent: Tue, December 1, 2009 12:33:16 PM
Subject: '65 Sat. rocker mldg. pic/info needed


I need to know if the rocker molding on a '65 Satellite is the same as a 
65 Bel II. If anyone has a conclusive answer, a picture or a picture 
source please send it to my email address. 

I have someone looking for the Satellite molding and I have the Bel II 
pieces. 

Dave Walters
Aurora, Co.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.