RE: Poly pin?

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

It took me a little longer than expected, about 10 minutes. I used a 
pair of channel lock pliers and turned it back and forth while prying up 
with a large screwdriver. As you can see the pliers did mar the pin head 
and it bent a tad. They are rather soft.

I have done this before and the other one was easier. I took the rocker 
shaft apart before too without difficulty. I'd spread some good 
penetrating oil all over it ahead of time and that should help.

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
=====================================================================
spigot2039@xxxxxxxxxxx wrote:
> 
> Thanks Rich. 
> http://1962to1965mopar.ornocar.com/images/318-poly-valve-pin.jpg shows 
> the pin. 
> 
> Was it difficult to remove, Rich?
> 
> Thanks,
> Gary H. 
> 
> 
> -----Original Message----- 
> >There is a shoulder that sits against the head surface. From that point 
> >to the tip it is 5/8" long. I sent Gary H some pictures of it.
> >
> >Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies 



Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.