RE: Air inlet.

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

Steve,
	It depends on whether the word "easy" should have been in your
question...  it's a simple matter of removing the dashboard and the
windshield, drilling out a zillion spot welds (did those guys get paid by
the weld?), a couple of hours of prying and coaxing, and you're in there!  

	Now if you had a '62-65 Dodge pickup, all you would need is a
phillips screwdriver...

SC

-----Original Message-----
From: Jimmy Peavy [mailto:peaver63@xxxxxxxxxxxxxx] 
Sent: Wednesday, October 07, 2009 8:08 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Re: Air inlet.


Nope!

MO ( Steve Mick) wrote:
>
> The grill in front of the windshield--heater fresh air inlet.. Is 
> there a way to get inside  of that plenum to clean out old dirt and 
> leaves? I would like to get in there and coat it with POR15 or some 
> rust encapsulator.. Also, where  does water that gets in there drain 
> out?.Thanks for any help..............MO
>
>


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.